Setting/Checking Modes 79
TM-L90/TM-L90 Peeler Model Technical Reference Guide
❏ Memory switch settings
Follow the steps below.
1. Close the roll paper cover.
2. Turn on the power while pressing FEED button. Keep pressing the button until the ERROR
LED comes on.
After printing the current status, a Continuing self-test guidance is printed, and the PAPER OUT LED
flashes.
3. Briefly press the FEED button (less than one second) to continue the self-test.
If the test does not continue, turn off the power.
When the self-test continues, rolling printing is performed with the loaded text.
After "*** completed ***" is printed, the printer initializes and switches to standard mode.
4.1.2 NV Graphics Information Print Mode
You can confirm the following information with this mode:
❏ Capacity of the NV graphics
❏ Used capacity of the NV graphics
❏ Unused capacity of the NV graphics
❏ Number of NV graphics that are registered
❏ Key code, number of dots in X direction, number of dots in Y direction, number of colors to
be defined.
❏ NV graphics data
Follow the steps below.
1. Close the roll paper cover.
2. Turn on the power while pressing FEED button. Keep pressing the button until the ERROR
LED comes on.
After printing the current status, a Continuing self-test guidance is printed, and the PAPER OUT LED
flashes.
3. Hold down the FEED button (for at least one second) to shift to Mode selection.
Mode selection guidance is printed, and the PAPER OUT LED flashes.
4. After briefly (less than one second) pressing the FEED button once, hold it down for at least
one second, to print the NV graphics information.
To Next Page
Loading...
