Setup 31
TM-L90/TM-L90 Peeler Model Technical Reference Guide
2.3.2 With the TM-L90 Peeler Model
In the following 2 cases, it is necessary to adjust the position of the roll paper near end sensor.
❏ When adjusting the detection position according to the thickness of the roll paper core
❏ When adjusting the amount remaining paper desired
Note:
Since the shape of the central part of the roll paper may differ slightly according to the specification, it is
not possible to detect near end exactly.
Part names and the locations of N.E. detector components
1. Open the peeler cover.
2. Open the roll paper cover.
3. Take out the roll paper.
sensor adjustment
screw
near end sensor
holder
near end sensor window (the photo
shows the sensor projecting from the
window)
To Next Page
Loading...
