Epson TM L90 - Page 124

124 Appendix
13: Other
Settings
1: Buzzer
Control
1: Select Buzzer Internal Buzzer, Option Buzzer, Buzzer Disable
2: Buzzer
Frequency
(Error)
Continuous
, 1 time, No sound
3: Sound
Pattern (Auto
cut)
Pattern A
, Pattern B, Pattern C, Pattern D, Pattern E
4: Buzzer
Frequency
(Auto cut)
1 time
, No sound
5: Sound
Pattern (Pulse 1)
Pattern A
, Pattern B, Pattern C, Pattern D, Pattern E
6: Buzzer
Frequency
(Pulse 1)
1 time, No sound
7: Sound
Pattern (Pulse 2)
Pattern A, Pattern B, Pattern C, Pattern D, Pattern E
8: Buzzer
Frequency
(Pulse 2)
1 time
, No sound
2: Interface
Settings
1: Receive
Buffer Capacity
4 KB
, 45 bytes
2: BUSY
Condition
Receive Buffer Full or Offline
, Receive Buffer Full
3: Auto Line
Feed
Always disabled
, Always enabled
4: State to
cancel buffer
BUSY
Not BUSY = 256 bytes
, Not BUSY = 138 bytes
5: Error Signal Enabled
, Disabled
3: Near-End LED Disabled, Enabled
4: Transmit the power ON
information
Does not transmit, Transmit
5: Recovery layout error DLE ENQ or Cover open/close
, DLE ENQ