158 Appendix
Die-cut label size
When manufacturing die-cut label paper, be sure that the paper meets the following
requirements.
Label Size Requirement
Note:
❏ Be sure to set the cutting position (L4) between labels.
❏ Be sure that the distance from the cutting position to the print starting position (=L3-L4) is 2.75 mm
{0.11"} or more.
Black mark position for die-cut label paper
If die-cut label with black marks is used, there are two reflective rate requirements, depending
on the size and position of black marks. Be sure to use label paper that meets either black mark
position requirement I or II as follows:
To Next Page
Loading...
