Appendix 163
TM-L90/TM-L90 Peeler Model Technical Reference Guide
Size of continuous label paper
To prevent the print head from sticking to the adhesive agent, be sure to use continuous label
paper that has a cut-off edge.
Note:
“cut-off edge” is a method of cutting and removing the edge of the label in advance so that the label can be
peeled off easily from the backing paper.
Requirements for Size of Label Paper of the Cut-Off Edge Type
Note:
When using a label with 80 mm {3.15"} paper width, the cut-off edge (b) is not necessary; however, it is
recommended that cut-off edges with approximately 2 mm {0.79"} width be provided for both edges so that
the label can be peeled off easily from the backing paper.
Black mark position for continuous label paper
Refer to "Black mark position for receipt paper" on page 156.
To Next Page
Loading...
