EW50 Industrial LTE Cellular Gateway
136
Check the Enable box to enable the TCP server configuration.
Click the Save button to save the configuration
Enable TCP Server Mode
Configure the gateway as a TCP (Transmission Control Protocol) Server. The TCP Server waits for connections to
be initiated by a remote TCP client devices to receive serial data. The setting allows user to specify specific TCP
clients or allow any to send serial data for serial data transmission bandwidth control and access control. The
TCP Server supports up to 4 simultaneous connections to receive serial data from multiple TCP clients.
Enable TCP Server Mode Window
Indicate the listening port of the TCP connection.
Value Range: 1 ~ 65535.
Allow All is set by
default
Choose Allow All to allow any TCP clients to connect. Otherwise choose
Specific IP to limit certain TCP clients.
1. Max. 4 connections
2. 1 is set by default
Set the maximum number of concurrent TCP connections. Up to 4
simultaneous TCP connections can be established.
Value Range: 1 ~ 4.
Enter the idle timeout in minutes.
The idle timeout is used to disconnect the TCP connection when the idle time
has elapsed.
Idle timeout is only available when On-Demand is selected in the Connection
Control field.
Value Range: 0 ~ 60 minutes.
Input the time period of alive-check timeout. The TCP connection will be
terminated if it doesn’t receive response of alive-check longer than this
timeout setting.
Value Range: 0 ~ 60 minutes.
Check the Enable box to activate the corresponding serial port in specified
operation mode.
Click Save button to save the settings.
To Next Page
Loading...
General