EW50 Industrial LTE Cellular Gateway
167
Authentication Configuration Window
1. Required setting
2. Pre-shared Key 8 to
32 characters.
Select Key Management from the dropdown box for this IPsec tunnel.
IKE+Pre-shared Key: user needs to set a key (8 ~ 32 characters).
IKE+X.509: user needs Certificate to authenticate. IKE+X.509 will be available
only when Certificate has been configured properly. Refer to Certificate section
of this manual and also Object Definition > Certificate in web-based utility.
Manually: user needs to enter key ID to authenticate. Manual key configuration
will be explained in the following Manual Key Management section.
Specify the Local ID for this IPsec tunnel to authenticate.
Select User Name for Local ID and enter the username. The username may
include but can’t be all numbers.
Select FQDN for Local ID and enter the FQDN.
Select User@FQDN for Local ID and enter the User@FQDN.
Select Key ID for Local ID and enter the Key ID (English letter or number).
Specify the Remote ID for this IPsec tunnel to authenticate.
Select User Name for Remote ID and enter the username. The username may
include but can’t be all numbers.
Select FQDN for Local ID and enter the FQDN.
Select User@FQDN for Remote ID and enter the User@FQDN.
Select Key ID for Remote ID and enter the Key ID (English letter or number).
Note: Remote ID will be not available when Dynamic VPN option in Tunnel
Scenario is selected.
To Next Page
Loading...