EVOCA La Radiosa - Cleaning the Mixers

12 05-2019 0073 00
CLEANING THE MIXERS
Each time a product is loaded and/or on a
weekly or more frequent basis, depending
on how often the appliance is used, the
quality of the incoming water and the prod-
ucts used, the mixers must be sanitised.
The parts that need to be cleaned are the
powder trays, mixers, instant drink dispens-
ing pipes and diuser.
5
4
6
3
2
1
Fig. 9
1. Instant powder funnel
2. Instant powder tray
3. Water funnel
4. Mixer fan
5. Instant beverage hose connection
6. Mixer locking ring
To clean the mixer, proceed as follows:
1. Disconnect the instant beverage hose
from the water funnel connection.
2. Turn the water funnel locking ring anti-
clockwise and remove the mixer from the
appliance.
3. Separate all the components (instant
product funnels, water funnels, convey-
ors and powder trays).
4. Remove the fans: block the disk fitted
on the motor mixer shaft with one finger,
then unscrew the mixer fan.
Fig. 10
5. Soak the components for about 20 min-
utes in a container filled with a pre-pre-
pared sanitising solution, whilst taking
care to mechanically remove the resi-
dues and visible films using swabs or
brushes if necessary.
6. Rinse thoroughly and dry each part care-
fully.
7. Reassemble the fans.
8. Reassemble the mixer parts and correct-
ly reposition the water funnel.
Check that it has been correctly inserted.
Fig. 11
9. Turn the water funnel locking ring clock-
wise in order to secure the mixer to the
appliance.