05-2019 0073 00 23
WATER SUPPLY
The appliance must use drinking water and
take into account the regulations in force
where the appliance is installed.
from tHE watEr maiNs
The mains water pressure must be be-
tween 0.12 and 0.85 MPa (1.2 - 8.5 bar).
Run the water from the mains until it is clear
and dirt free.
Connect the water mains to the 3/4” tting
of the water inlet solenoid valve via a food
grade pipe (also available as a kit) that can
withstand the water mains pressure (mini-
mum internal diameter of 6 mm).
We recommend installing a tap on the
water mains outside the appliance, in
an accessible position.
Only use new seal and hose sets and
do not reuse any existing materials.
DEscalEr
The appliance is not supplied with a water
softener.
In the event that the appliance is connect-
ed to a water mains with very hard water, a
water softener must be installed.
The water softeners that are available as
accessory, need to be periodically regener-
ated according to the instructions provided
by the manufacturer.
Use water softeners that have a big enough
capacity to be eectively used in the appli-
ance.
If the appliance uses a water tank, appro-
priate lter cartridges can be used.
1
Fig. 25
1. 3/4”G water inlet fitting
To Next Page
