English
INTRODUCTION 1
transport and storagE 1
what to do should a malfunction occur 2
appliancE idEntification and fEaturEs 2
positioning thE appliancE 3
tEcHNical spEcificatioNs 3
powEr consumption 5
CLEANING AND LOADING 6
main switch and safEty mEasurEs 6
hygiEnE and clEaning 7
using hot bEvEragE vEnding machinEs (dispEnsing into
opEn containErs) 8
coNtrols aND iNformatioN 8
loaDiNg proDucts 9
coffEE bEans 9
instant products 9
milk 10
intErnally suppliEd tank watEr 10
pErioDical opEratioNs 10
clEaning thE rEsiduE trays 11
clEaning thE mixErs 12
clEaning thE nozzlEs and spouts 13
clEaning thE brEwing unit 14
clEaning thE milk tank 14
clEaning thE watEr supply tank 14
switching thE machinE on 14
wasH cyclEs 14
rinsing thE componEnts 15
washing thE cappuccino makEr 15
brEwing unit wash cyclE 18
clEaning thE touchscrEEn 19
sErvicE suspEnsion 19
INSTALLATION 20
unpacking thE appliancE 20
switchEs and safEty dEvicEs 21
discarding thE solid and liquid rEsiduEs 22
rEmoving thE sidE and rEar panEls 22
watEr supply 23
ElEctrical connEction 24
installing sidE modulEs 25
connEctivity indications 25
iNitial start-up 26
first sanitisation 27
opEratioN 27
brEwing unit 27
variablE-dosE coffEE dosEr 29
dispEnsing hot watEr from thE spout 30
Evomilk cappuccino makEr 30
calibration chEcks and sEttings 30
connEctivity 32
touchscrEEn 32
usiNg usb mEmory sticks 33
opEratiNg iN Normal usEr moDE 33
dispEnsing a bEvEragE 33
opEratiNg iN barista moDE 34
appliancE status panEl 34
systEm architEcturE 35
PROGRAMMING 36
accEssing thE programming mEnus 36
EntEring valuEs 37
Daily actioNs 38
clEaning and washEs 38
Emptying thE solid rEsiduE tray 38
monEy managEmEnt 38
sElEctioN sEttiNgs 39
display layout 39
display layout of thE sElEction catEgoriEs 39
sElEction catEgoriEs 39
bEvEragEs 39
rEcipEs 40
containErs 44
physical layout 44
Evomilk sEttings 44
macHiNE sEttiNgs 45
configuration 45
modifying intErfacE strings 45
customising thE intErfacE 45
gEnEral display sEttings 46
playlist 46
input sEnsor sEttings 46
calibrating thE flow mEtEr 46
grindEr calibration 46
motor-dosEr calibration 47
pump/solEnoid valvE calibration 47
output sEttings 47
maintEnancE 48
gEnEral sEttings 48
hEating unit paramEtErs 49
mixEr anti-lock 49
motorisEd adjustmEnt of thE burrs 49
nExt maintEnancE 49
To Next Page
Loading...
