44 05-2019 0073 00
basic Evomilk paramEtErs
You can set the:
-Set the name of the ingredient.
-The dose (water and powder).
-The milk preparation profile to be used;
the profiles are set by default by the manu-
facturer.
Each milk profile has specific temperature
and emulsion with air parameters.
Depending on the profile(s) used in the
recipe, different end cup results can be
obtained.
-The milk dispensing time with the chosen
profile.
aDvaNcED Evomilk milk paramEtErs
start
DElay
Set a time delay for when to dispense the
milk, after the previous ingredient.
It can help the beverage be presented bet-
ter.
start-up DraiNagE
Sets the time needed to drain the milk hose
before a milk-based selection can be dis-
pensed.
coNtaiNErs
According to the machine layout, how the
product containers have been arranged can
be shown.
Choose a container in order to:
-Assign a name to the container.
-Associate an ingredient to the container
(Chocolate, Espresso, 2 espressos, etc.).
-Set the container’s maximum capacity so
that the "product running out" check can
be managed.
-Change the colour associated with the
container.
pHysical layout
It is the mechanical layout of the congura-
tion used by the appliance.
It shows the set-up of the containers and
main functional units.
The appliance's new mechanical settings
can be indicated to the software.
-
spond with the appliance’s actual con-
The appliance adjusts the operating
cycles of the functional units according
to the choices that have been made.
Settings that do not comply with the
and cause damage to the appliance.
Evomilk sEttiNgs
Evomilk
DispENsiNg paramEtErs
The percentage of air/milk emulsion and
the heating temperature can be set for each
of the milk preparation proles.
When the air/milk emulsion values are high,
a greater volume of frothed milk will be
obtained.
This function allows the new settings to be
tested, in order to check the result.
To Next Page
Loading...
