05-2019 0073 00 57
PAYMENT SYSTEMS
Certain models only.
It is possible to decide which of the pay-
ment system protocols to enable and which
functions to manage.
Some of the parameters, which are used in
numerous payment systems, keep the set
value even if the system type is changed.
commoN paramEtErs
immEDiatE cHaNgE
Usually the amount for a selection is
cashed in after the appliance sends the
“Selection made” signal.
By enabling this function, which is disabled
by default, the payment signal is sent when
the beverage starts being dispensed.
This parameter must be set.
DEcimal poiNt positioN
Set the decimal point position, i.e.:
0: decimal point is disabled
1: XXX.X (one decimal place)
2: XX.XX (two decimal places)
3: X.XXX (three decimal places)
typE of DispENsiNg
This allows you to set the operating mode
for multiple or single dispenses. With multi-
ple dispensing, the change is not automat-
ically returned when one beverage has n-
ished being dispensed; it remains available
for further dispenses. When the return coins
button is pressed, the remaining credit will
be returned if its value is less than the maxi-
mum change value.
obligatioN to buy
This enables/disables the return coins key
before a product is dispensed.
-ON: the change is returned after a product
has been selected.
-OFF: the change is returned immediately
when the return coins button is pressed
(the appliance works as a change ma-
chine).
valiDator
DEcimal poiNt positioN
Set the decimal point position, i.e.:
0: decimal point is disabled
1: XXX.X (one decimal place)
2: XX.XX (two decimal places)
3: X.XXX (three decimal places)
ovErpay
You can decide whether to:
-Collect any credit in excess of the selec-
tion amount after a certain time in seconds
(parameter "000 deleted").
-Leave any credit in excess of the selection
amount available for a subsequent selec-
tion (parameter "kept").
ovErpay timEout
Makes it possible to set the time when the
credit will be released if a selection hasn’t
been made.
To Next Page
