52 05-2019 0073 00
HEatiNg uNit lEak
Signals a possible loss of heating unit pres-
sure during a “pressurised” cycle.
fully clEaNiNg tHE macHiNE
Signals that the appliance needs to be fully
cleaned.
The warning is displayed when the set time
limit or number of selections is reached.
wasHiNg tHE EsprEsso uNit witH poDs
Signals that the espresso unit needs to be
cleaned with sanitising pods.
The warning is displayed when the set time
limit or number of selections is reached.
fully wasHiNg tHE cappucciNo makEr
Signals that the milk circuit needs to be fully
washed (with detergent).
wasHiNg tHE cappucciNo makEr
Signals that the milk circuit needs to be
washed/ rinsed.
wasHiNg tHE mixErs
Signals that the mixers need to be washed.
The warning is displayed when the set time
limit or number of selections is reached.
tHE liquiD rEsiDuE tray is full
Indicates that the liquid residue tray needs
to be emptied because it is full.
missiNg liquiD rEsiDuE tray
The liquid residue tray has not activated the
microswitch that indicates the presence of
the tray.
Check that the liquid residue tray has been
correctly positioned inside the appliance.
low watEr prEssurE
The pressure switch measures low water
pressure inside the appliance’s hydraulic
circuit.
milk lEvEl
Only for the combined cooling module.
The module sensor detects that the milk
in the milk tank has reached the minimum
level.
Evomilk DispENsED tEmpEraturE probE
Only for the Evomilk module
The temperature of the milk leaving the
Evomilk module (measured by the probe) is
out of range (< 0°C or > 200°C); the probe
might be faulty or disconnected.
Evomilk iNl Et tEmpEraturE probE
Only for the Evomilk module
The temperature of the milk entering the
Evomilk module (measured by the probe) is
out of range (< 0°C or > 200°C); the probe
may be faulty or disconnected.
To Next Page
