Test Setup - Test Configurator, Timer, and System
MaxTester 127
MAC/IP/UDP
IP
For IPv4 the following configuration parameters are available.
Automatic IP (DHCP) check box, when selected (cleared by default),
allows obtaining an IP address dynamically from a DHCP (Dynamic
Host Configuration Protocol) server.
Source IP Address allows entering the source IP address for the
stream. The default setting is 10.10.x.y, where x and y are respectively
the two least significant bytes of the port default MAC address. Not
available when the Automatic IP (DHCP) check box is selected.
Destination IP Address allows entering the destination IP address for
the stream. The default setting is the source IP address.
For IPv6 the following configuration parameters are displayed: Source
Link-Local IPv6 Address, and Source Global IPv6 Address. Tap on the
IPv6 Config button to access all settings.
Link-Local IPv6 Address (LLA) is used for local communication
between on-link neighbors and for Neighbor Discovery process.
Mode
Stateless Auto (default) allows automatic generation of the IPv6
address based on the MAC address.
Static allows entering the IP Address.
Address, available with Static mode, allows selecting the
Link-Local IPv6 Address. The accepted range is from
FE80:0000:0000:0000:0000:0000:0000:0000 to
FE80:0000:0000:0000:FFFF:FFFF:FFFF:FFFF. The default address
is FE80::[Interface ID], where [Interface ID] is generated from
the source MAC address. When the Address field is selected for
editing using virtual keyboard, the Previous IPs button appears
allowing the selection of a previously configured IP address.
To Next Page
Loading...
