Test Setup - Test Configurator, Timer, and System
MaxTester 131
MAC/IP/UDP
TTL (IPv4) or HOP Limit TTL (IPv6) sets the Time To Live value: 1 to
255 (default is 128).
Flow Label (IPv6) is a number used to identify a series of related
packets from a source to a destination: 0 (default) to 1048575.
IP TOS/DS (IPv4) or Traffic Class (TOS/DS) - (IPv6) allows entering
either an hexadecimal value, 00 (default) to FF, or tap on the TOS/DS
Config button to set each TOS or DS parameter individually. Changing
the IP TOS/DS value will affect the TOS/DS Config settings and vice
versa.
TOS/DS Config button allows setting the Type of Service or the
Differentiated Service parameters.
TOS/DS
TOS/DS allows selecting either Type Of Service (TOS) or
Differentiated Services (DS).
Binary/Hex allows displaying, once this pop-up is closed, the IP
TOS/DOS value either in binary or hexadecimal.
Type Of Ser vice (available when TOS is selected).
Precedence value:
000 (Routine) (Default)
001 (Priority)
010 (Immediate)
011 (Flash)
100 (Flash Override)
101 (CRITIC/ECP)
110 (Internet Control)
111 (Network Control)
Delay allows the selection of the delay level: Normal (default) or
Low.
Throughput allows the selection of the throughput level:
Normal (default) or High.
To Next Page
Loading...
