Test Setup - Test Configurator, Timer, and System
158 MAX-800 Series
Services - Profile
Test Parameters
Note: Unit selection is available from the SLA Parameters on page 159.
For Dual Test Set, parameters are configurable for both local (L) and
remote (R) directions.
For Dual Port topology, parameters are configurable for both port
directions.
Traffic Policing check box when selected (default) allows stressing
the rate limiting of the network by sending traffic at higher rate than
committed by the SLA.
Burst Max Rate allows setting the rate that is used for the CBS and EBS
burst tests. Only available when the Burst Test is enabled (see
EtherSAM - Global on page 99).
Note: Changing a criteria value (CIR, CIR+EIR, Ramp Traffic Policing, or Burst
Max Rate) may affect the other criteria values in order to comply to the
following rules:
CIR CIR+EIR Ramp Traffic Policing Rate Line Rate
CIR CIR+EIR Burst Max Rate Line Rate
However, make sure that the criteria values comply to the following rule
with an adequate margin, as per ITU-T Y.1564 standard, for a burst test to
be valid:
CIR CIR+EIR Burst Max Rate Line Rate
To Next Page
Loading...
