Test Control
MaxTester 393
Report Button
Config/Save Tab
The Config/Save tab allows configuring the report parameters and
generating/saving the report.
Tap the Report button and the Config/Save tab.
Job Information parameters, not mandatory, are used to identify the
source of the report. Enter the following job information if required:
Job ID, Contractor Name, Customer Name, Operator Name, Circuit
ID, and Comment. Up to 30 characters are allowed for each parameter
at the exception of Comment for which 256 characters are allowed.
Restore Default reverts all Job Information parameters back to the
default values.
Report Headlines and Content parameters are used to identify the
report and are not mandatory. Up to 30 characters are allowed for each
parameter.
Report Header could be the company name.
Report Title could be the name of the product, name of test, test
number, etc.
Optional Content allows choosing the optional content that can
be part of the report:
All (default) includes all optional content to the report.
None excluded all optional content from the report.
Custom allows selecting the optional content to be part of the
report.
Choose Content, available when the Optional Content is set to
Custom, allows selecting what will be part of the custom content.
To Next Page
Loading...
