Extron electronics DTP CrossPoint 4K Series - Recall a Preset

DTP CrossPoint 4K Series Matrix Switchers • Matrix Software 125
3. Mark the desired gain and/or processor blocks:
a. Click a processor block. The block is marked by a green outline ( ).
The processor block and all of its settings is selected to be saved as a preset.
b. Ctrl-click additional processor blocks as desired.
TIP: To mark multiple successive processor blocks in
a chain, use right-click > Mark Row.
4. Save the preset:
a. Click Tools > Presets > Save Presets.
The Save a Preset dialog box opens.
b. As desired, enter a specific preset number
c. As desired, enter a preset name.
NOTE: Unless you enter a specific number, name, or both, the DSP Configurator
enters the next unused preset number and the name “Preset {number}.”
d. Click OK.
Recall a preset
Recall a preset as follows:
1. Select the desired preset in the Presets drop-down menu (see figure 69,
1
).
The selected preset appears in the Presets drop-down menu, marked processors
appear indicated by green boxes, ties that will be loaded as part of the preset are
shown by dashed lines, and ties that will be eliminated by the preset are indicated by
the output node highlighted in green.
2222222222
11
11111111
Figure 69. Recalling a Preset
NOTES:
• The Recall, Cancel, and Delete buttons appear when a preset is selected.
• An asterisk (*) in the drop-down menu indicates that a preset that only
exists in the switcher has not been saved to the configuration file of the DSP
Configurator. The ties and settings of the preset are not in sync between the
DSP Configurator program and the switcher.
• Presets marked with an asterisk should be recalled and then the current DSP
Configurator settings saved. Click File > Save or File > Save As.
• It may take up to two seconds for the preset data to read-in in Live mode.
2. Click Recall to load and make active the selected preset (
2
).
TIPS:
• Click Cancel to discard the preset recall (but not deleting the preset) and return
to the current configuration.
• Click Delete to permanently erase the preset.