DTP CrossPoint 4K Series Matrix Switchers • Operation 46
Configuring the TP Insertion Ports
The control signal insertion ports on TP inputs and outputs can be configured for Ethernet
insertion or RS-232 pass-through (see the following table for TP input and output insertion
ports by matrix size).
Matrix Ports Matrix Ports
Inputs 10x8 7, 8, 9, 10 All others 7 and 8
Outputs
10x8 5, 6, 7, 8 8x6 3, 4, 5, 6
8x4 3, 4 8x2 1, 2
Configure the control insertion as follows:
1. Press the Esc button to clear any input button indications, output button indications, the
Logo button, or control button indications that may be lit.
2. Select Control Insert Configuration mode: Press and hold the Input 4 and
Output 4 buttons simultaneously until the Video and Audio button begin to blink
(approximately 2 seconds).
I/O
AUDIOVIDEO
1
2
3
4
1
2
3
4
OUTPUTS
Press and hold the buttons.
2 seconds
3. Release the input and output buttons.
NOTE: The TP insertion ports are protected when front panel Lock mode 2 is
selected. You can view the port configurations in Lock mode 2 but you cannot
change them from the front panel (see Setting the Front Panel Locks
(Executive Modes) on page 48).
If front panel Lock mode 2 is selected (the default setting) and you try to perform
steps 4 and 5, the actions are ignored and the Enter, Video, and Audio buttons
flash.
4. Select the input or output and configure it: Press and release either an input
button or output button to select that input or output to configure. Repeatedly press
the input or output button, toggling between unlit and amber indications, to select the
configuration.
NOTE: Only TP inputs and outputs are valid selections. Other input and output
buttons do not respond.
6
7
6
7
TS
TS
CONTROL
ENTER PRESET
VIEW
ESC
Press the button repeatedly.
Press
Press
The selected input or output button indicates the
control insertion configuration as follows:
Unlit — RS-232 pass-through Amber — Ether
The Enter button b
links to indicate
the need to save the change.
To Next Page
Loading...
