Extron electronics DTP CrossPoint 4K Series - Viewing the Configuration

DTP CrossPoint 4K Series Matrix Switchers • Operation 39
Viewing the Configuration
The current configuration can be viewed using the front panel buttons. The View-only mode
prevents inadvertent changes to the current configuration.
View the current configuration as follows:
1. Press the Esc button to clear any input button indications, output button indications, the
Logo button, or control button indications that may be lit.
2. Press and release the View button. View lights green. All of the buttons light for outputs
that are not tied as follows:
• Amber to indicate no video and audio ties
• Green to indicate no video only ties (audio ties exist)
• Red to indicate no audio only ties (video ties exist)
If you press an output button for which there are no ties, the output buttons light for all
outputs without ties.
3. Press the Video button, Audio button, or both, to select video, audio, or both, to view.
4. Select the desired input or outputs whose ties you wish to view by pressing the input
and output buttons.
NOTES:
• To see all ties of the current configuration, press and release each input and
output button, one at a time, with the Video button and the Audio button lit.
• When you view video and audio ties, the Video button is lit green and the
Audio button is lit red. After you select an input or output, the output buttons
light different colors to show where video and audio ties are not the same
(audio is broken away).
• After 30 seconds of front panel inactivity, View-only mode automatically
deselects.
Example 4: Viewing video and audio, audio only, and video only ties
NOTE: This example assumes that you have performed example 1 on page 36 and
example 2 on page 37, and example 3 on page 38.
1. Clear all selections: Press and release the Esc button.
2. Select View-only mode: Press and release the View button. The View button lights red.
3. Select video and audio for viewing: Press and release the Video button and the
Audio button as necessary to light both.
I / O
VIDEO AUDIO
12345678
OUTPUTS
Until you select an input, the buttons for all untied outputs
light the appropriate color:
Amber if no inputs are tied (not shown in this example)
Green if no video inputs are tied (only audio is tied)
Red if no audio inputs are tied (only video is tied).
Press the Audio b
utton
to toggle on and off.
The button lights red
when selected.
Press the
Video button
to toggle on and off
.
The b
utton lights green
when selected.