DTP CrossPoint 4K Series Matrix Switchers • Matrix Software 96
DSP Configurator Program
The DSP Configurator can connect to the switcher via any rear panel LAN port or the front
panel Configuration port. Use of the rear panel Remote (RS-232) port is not recommended.
Starting the Program
NOTE: Extron recommends connection via an Ethernet LAN port for the DSP
Configurator program.
Start the DSP Configurator Program by clicking the desktop icon or as follows:
1. Click Start > All Programs > Extron Electronics > DSP Configurator > DSP
Configurator. The DSP Configurator startup screen displays (see figure 52).
2222222222
11
11111111
Figure 52. DSP Configurator Screen and DTP CrossPoint Selection
2. Select the DTP CrossPoint switcher in the drop-down menu (see figure 52,
1
).
3. Click OK (
2
).
TIP: If you have only DTP CrossPoint switchers of the same model, click Always
perform the selected action to eliminate step 2 in future startups.
The DSP Configurator program starts in Emulate mode (see figure 53 on the next page).
NOTE: Figure 53 is a composite view of the entire DSP Configurator program
window configured for the 10x8 matrix size.
• As a view, it is necessarily small. Expanded views of the applicable segments
are provided where those segments are detailed.
• Other matrix sizes have fewer inputs and outputs.
To Next Page
Loading...
