Extron electronics DTP CrossPoint 4K Series - Selecting Lock Mode 2 or Toggling between Mode 2 and Mode 0; Selecting Lock Mode 2 or Toggling between Mode 2 and Mode 1

DTP CrossPoint 4K Series Matrix Switchers • Operation 49
Selecting Lock mode 2 or toggling between mode 2 and mode 0
NOTE: If the switcher is in Lock mode 0 or mode 1, this procedure selects mode 2. The
Esc, Video, and Audio buttons blink twice.
If the switcher is in Lock mode 2, this procedure selects mode 0 (unlocks the
switcher). The Video and Audio buttons blink twice.
Toggle the lock on and off by pressing and holding the Enter button, the Video button, and
the Audio button simultaneously for approximately 2 seconds (see figure 32).
Lock mode 2
Lock mode 0
CONTROL I/O
AUDIOVIDEO
I/O
AUDIOVIDEO
ENTER PRESET
VIEW
ESC
CONTROL I/O
AUDIOVIDEO
ENTER PRESET
VIEW
ESC
CONTROL I/O
AUDIOVIDEO
ENTER PRESET
VIEW
ESC
Press and hold for 2 seconds.
Press and hold for 2 seconds.
Figure 32. Toggling Front Panel Lock Between Mode 2 and Mode 0
Selecting Lock mode 2 or toggling between mode 2 and mode 1
NOTES:
• If the switcher is in Lock mode 0 or mode 1, this procedure selects mode 2.
• If the switcher is in Lock mode 2, this procedure selects mode 1.
Toggle the lock on and off by pressing and holding the Video button and the Audio button
simultaneously for approximately 2 seconds (see figure 33).
Lock mode 1
Lock mode 0
I/O
AUDIOVIDEO
I/O
AUDIOVIDEO
CONTROL I/O
AUDIOVIDEO
ENTERPRESET
VIEW
ESC
I/O
AUDIOVIDEO
Press and hold for
2 seconds.
Press and hold for
2 seconds.
Figure 33. Toggle Front Panel Lock Between Mode 2 and Mode 1