Extron electronics DTP CrossPoint 4K Series - Front Panel Controls and Indicators

DTP CrossPoint 4K Series Matrix Switchers • Operation 25
Operation
This section describes the front panel operation of the DTP CrossPoint 4K Series, including:
• Front Panel Controls and Indicators
• Front Panel Operations
• Rear Panel Operations
•
Ethernet to RS-232 Insertion
• Troubleshooting
• Configuration Worksheets
Front Panel Controls and Indicators
The front panel controls (see figure 24 and figure 25 on the next page) are grouped into four
sets. The input and output buttons,
A
and
B
, are grouped on the left side of the control
panel. The Logo Select, control, and video and audio (I/O) selection buttons,
C
through
I
, are grouped in the center of the panel. The volume controls (
J
and
K
) and the IPCP
indications (IPCP models only,
L
) are on the right side of the panel.
DTP CROSSPOINT 4K SERIES
DIGITAL PRESENTAT ION MATRIX
Extron
12345678
CONFIG
VOLUME
CONTROL
MIC VOLUME
I/O
OUTPUTS
123 4 567 8 9 10
INPUTS
AUDIOVIDEO
LOGO
ENTER PRESET VIEW ESCSELECT
RTS
CTS
Tx
Rx
OVER
LIMIT
S
1
2 3 2
1
3 4
12
3
1
4
2
eBUS
COM
IR/S I/O
RELAYS
C D E F G H I
A L
B J K
Figure 24. Front Panel, DTP CrossPoint 4K Series (IPCP Model)
A
Input buttons (see page 27)
B
Output buttons (see page 29)
C
Logo button (see page 29)
D
Enter button (see page 30)
E
Preset button (see page 30)
F
View button (see page 31)
G
Esc button (see page 31)
H
Video button (see page 32)
I
Audio button (see page 32)
J
Mic Volume (gain) knob and LEDs (see page 32)
K
Volume (gain) knob and LEDs (see page 32)
L
IPCP Pro 350 control processor LEDs
(IPCP models) (see page 33)