Extron electronics DTP CrossPoint 4K Series - Enabling Ethernet and Captive Screw Insertion; Ethernet to RS-232 Insertion

DTP CrossPoint 4K Series Matrix Switchers • Operation 54
Enabling Ethernet and Captive Screw Insertion
For a TP port to distribute the inserted signal, it must be enabled for either Ethernet insertion
or captive screw insertion (default). The simplest way to make this selection is via the front
panel (see Configuring the TP Insertion Ports on page 46).
Alternatively, you can make this selection:
• Using the Product Configuration Software (see Configuring RS-232 Insertion
Parameters on page 91)
• Using SIS commands (see the Captive screw and Ethernet serial port insertion
enables SIS commands on page 81)
Ethernet to RS-232 Insertion
Figure 37 is an example of a typical Ethernet to RS-232 insertion, in which an Extron IPCP
module provides control of an HD camera via the matrix switcher. Configure this type of
insertion as follows:
1. Connect a TP cable from the IPCP module to the LAN port, directly or via a network.
2. If necessary, enable the port (input port 7 in this example) for Ethernet (see “Enabling
Ethernet and Captive Screw Insertion,” above).
3. If necessary to match the device to be controlled, configure the port RS-232 protocol
(baud rate, parity, data bits, and stop bits) (see RS-232 protocol on the next page).
4. Connect the TP cable to the endpoint as usual.
5. Connect a serial cable from the endpoint to the device to be controlled.
50-60 Hz
100-240V ~ -- A MAX
SIG LINK
OUT
1
1 23456
3A 4A
4B 4
RS-232 IR
RS-232 IR
Tx Rx Tx RxG
Tx Rx Tx Rx
XTP
RESET
R
S/PDIF
OUT
DTP
XTP
DTP
XTP
DTP
XTP
DTP
+48V
MIC/LINE
1
1
3
2
4
2
3
4
LINK
EXP
HDBT
HDBT
G
7
8
DTP CROSSPOINT 84 4K
RS-232 IR
Tx Rx Tx RxG
OVER TP
OVER TP
SIG LINK
IN
SIG LINK
IN
AUDIO OUTPUTS
AUDIO INPUTS
DMP EXPANSION
CONTROL
AMP OUTPUT
INPUTS
OUTPUTS
SIG LINK
OUT
3B
RS-232 IR
Tx Rx RTSCTS G
1
LR
1
LR
3
LR
3
LR
5
LR
2
LR
4
LR
2
LR
4
LR
6
LR
Tx Rx G
12
12
SGSG
C
34C+V
PWR OUT = 6W
+S -S G
Tx Rx G Tx Rx G1234G
REMOTE
COM 1 COM 3COM 2 DIGITAL I/O
LAN 1
LAN 2LAN 3
CLASS 2 WIRING
1
LR
8Ω / 4Ω
IR/SERIAL RELAYS eBUS
AUDIO
INPUTS OVER DTP
RS-232
IR
Tx Rx Tx RxG
POWER
12V
0.7A MAX
SIG LINK
DTP OUT
DTP HDMI 4K 230 Tx
LAN1
I
N
SIG LINK
T
x
Rx
T
G
RS-232
Insertion
RS-232
RS-232
Network
DTP CROSSPOINT 84 4K
HD Camera
Figure 37. Typical Ethernet to RS-232 Insertion to an Input Endpoint