DTP CrossPoint 4K Series Matrix Switchers • Programming Guide 64
USB Port
The front panel Configuration port (see item
A
on page 24) is a standard USB port. A USB
cable, terminated on one end with a USB mini-B male connector, is available at any local
electronics store.
Ethernet (LAN) Ports
The Ethernet cable can be terminated as a straight-through cable or a crossover cable and
must be properly terminated for your application (see item
Q
[non-IPCP model] or item
R
[IPCP models], both on page 17).
• Crossover cable — Direct connection between the computer and the DTP CrossPoint
switcher.
• Patch (straight-through) cable — Connection of the DTP CrossPoint switcher to an
Ethernet LAN or direct connection between the computer and switcher.
Default IP addresses
To access the DTP CrossPoint switcher via the LAN port, you need the IP address for the
unit, and may need the subnet mask and the gateway address. If the IP address has been
changed to an address comprised of words and characters, you can determine the actual
numeric IP address for the DTP CrossPoint using the ping (ICMP) utility. For all control
access information and other details for the IPCP Pro 350, see the IPCP Pro Series User
Guide at www.extron.com.
The factory-specified defaults are:
DTP CrossPoint 4K Series IPCP Pro 350
IP address 192.168.254.254 192.168.254.250
Subnet mask 255.255.0.0 255.255.255.0
Gateway address 0.0.0.0 0.0.0.0
NOTE: For IPCP models:
• The values listed above are the same for all three LAN ports.
• The LAN ports give access to either the DTP CrossPoint or the built-in IPCP control
processor.
• The unused ports function as a simple, multiport, unmanaged network switch so
that you can connect additional devices to the same network.
To Next Page
Loading...
