Extron electronics DTP CrossPoint 4K Series - Rear Panel Operations

DTP CrossPoint 4K Series Matrix Switchers • Operation 43
Assigning and Unassigning Logos
A logo is a saved bitmapped image that can be superimposed on top of a scalable output
(see the table below for scalable outputs by matrix size).
Matrix Outputs Matrix Outputs
10x8 5, 6, 7, 8 8x6 3, 4, 5, 6
8x4 3, 4 8x2 1, 2
NOTES:
• The switcher has memory space for 16 bitmapped logos.
• Logos are created and saved using the Product Configuration Software (see the
PCS Help file).
Example 6: Assigning logos
Set the switcher to display a logo on one or more of the scalable outputs as follows:
1. Press the Esc button to clear any input button indications, output button indications, the
Logo button, or control button indications that may be lit.
2. Select Logo mode: Press and release the Logo Select button.
SELECT SELECT
LOGOLOGO
123 4 567 8 9 10
INPUTS
12345678
OUTPUTS
The button lights.Press and release.
Lit input buttons identify the first 10 saved logo files.
A lit output button identifies an output that has a logo assigned.
3. Select the logo file: Press and release the input button for the desired logo.
123 4 567 8 9 10
INPUTS
Push the button.
The button blinks to indicate the selection.
4. Assign the logo: Press and release one or more output buttons to assign the logo to
those outputs.
ENTER
12345678
OUTPUTS
Push the desired output buttons.Outputs 1through 4 are
not selectable.
The buttons blink to indicate the selection.
Enter blinks to indicate the
need to confir
m the assignment.
5. Confirm the change: Press and release the Enter button.
ENTER
All input buttons and output buttons
return to unlit or bac
kground illumination.
Press the Enter button
to confirm the change.
The
Enter button returns to
unlit or background illumination.