DTP CrossPoint 4K Series Matrix Switchers • HTML Pages 153
Download the Startup Page and View Switcher Status
Access the switcher using HTML pages as follows:
1. Start the Web browser program.
2. Click in the Address field of the browser and highlight any existing text.
3. Enter the IP address of the switcher in the Address field of the browser.
NOTE: If the local system administrators have not changed the value, the
factory-specified default, 192.168.254.254, is the correct value for this field.
4. Press <Enter>. The switcher checks to see if it is password protected.
If the switcher is not password-protected, it downloads the HTML page (see figure 83
on the next page).
If the switcher is password-protected, the switcher downloads the Authentication
Required dialog box (see figure 82).
Figure 82. Authentication Required Dialog Box
NOTE: By default, the User Name is either admin or user, depending on the level of
authentication requested.
5. Click in the User Name field and enter in the appropriate name.
6. Click in the Password field and enter in the appropriate administrator or user password.
Click the OK button.
The switcher downloads the factory-installed HTML page (see figure 83).
NOTE: Figure 83 is a composite view of the entire HTML page (full screen without
scrolling), configured for the 10x8 matrix size.
Other matrix sizes have fewer inputs and outputs:
• 8x6 matrix size: Inputs 1 through 8, outputs 1, 2, 3A, 3B, 4A, 4B, 5, and 6
• 8x4 matrix size: Inputs 1 through 8, outputs 1, 2, 3A, 3B, 4A, and 4B
• 8x2 matrix size: Inputs 1 through 8, outputs 1A, 1B, 2A, and 2B
To Next Page
Loading...
