Extron electronics DTP CrossPoint 4K Series - Performing a System Reset from the Front Panel

DTP CrossPoint 4K Series Matrix Switchers • Operation 50
Performing a System Reset from the Front Panel
The front panel reset is identical to issuing the E ZQQQ} SIS command (see the System
reset (factory default) SIS command on page 76). A system reset performs the following
functions:
• Clears all ties and presets
• Clears all mutes
• Enables all RS-232 pass-throughs
• Restores group masters 1 and 2 to their factory defaults (Mic volume and Volume)
NOTES:
• System reset does not reset the Internet protocol (IP) settings or replace
user-installed firmware.
• This function resets only the switcher, not any connected DTP endpoints.
Reset the switcher to the factory default settings by pressing and holding the View button
and Esc button simultaneously while you apply AC power to the switcher (see figure 34).
CONTROL
VIEW
ESC
Press and
hold
the buttons
simultaneously while you
apply power to the switcher.
Release the buttons.
Powe
r
The s
witcher flashes
the b
utton indicators
and then tur
ns them off.
Continue to hold the View and Esc
buttons until all input and output buttons
return to unlit and the Video and Audio
buttons light.
Figure 34. System Reset
NOTE: If background illumination was turned on before the reset, the I/O and control
buttons are unlit after the reset. When you cycle power, background illumination
returns to the condition that you previously selected.