Extron electronics DTP CrossPoint 4K Series - Configuring the Input Audio

DTP CrossPoint 4K Series Matrix Switchers • Operation 45
Configuring the Input Audio
The input audio can be configured to tie the digital audio input (on the HDMI or TP
connector), the analog audio input (on the local connector), or to automatically select the
input. For the automatic selection, digital has priority. Configure the input audio as follows:
1. Press the Esc button to clear any input button indications, output button indications, the
Logo button, or control button indications that may be lit.
2. Select Input Audio Configuration mode: Press and hold the Input 2 and Output 2
buttons simultaneously until the View and Esc buttons begin to blink (approximately
2 seconds).
1
2
3
1
2
3
CONTROL
ENTER PRESET
VIEW
ESC
Press and hold the buttons.
2 seconds
3. Release the input and output buttons.
NOTE: The audio configuration is protected when front panel Lock mode 2 is
selected. You can view the configuration in Lock mode 2 but you cannot change it
from the front panel (see Setting the Front Panel Locks (Executive Modes) on
page 48).
If front panel Lock mode 2 is selected (the default setting) and you try to perform
steps 4 and 5, the actions are ignored and the
Enter, Video, and Audio buttons
flash.
4. Select the input and configure it: Press and release an input button to select that
input to configure. Repeatedly press the input button, cycling through unlit, green, and
amber indications, to select the configuration.
4
5
INPUTS
4
5
INPUTS
4
5
INPUTS
CONTROL
ENTER PRESET
VIEW
ESC
Press the button repeatedly.
Press
Press
Press
The selected input button indicates the audio input configuration as follo
ws:
Unlit — auto mode Green — digital audio Amber — analog audio
(default)
The Enter button blinks to indicate
the need to save the change.
The View and Esc buttons continue
to blink.
5. Confirm the change: Press and release the Enter button.
ENTER
All input buttons and output buttons
return to unlit or bac
kground illumination.
Press the
Enter
button
to confirm the change.
The
Enter button returns to
unlit or background illumination.
6. Repeat steps 2 through 5 as necessary for other inputs.