Extron electronics DTP CrossPoint 4K Series - Making Ties

DTP CrossPoint 4K Series Matrix Switchers • Operation 35
Making Ties
The current configuration can be changed using the front panel buttons. Change the current
configuration as follows:
1. Press the Esc button to clear any input button indicators, output button indicators, or
control button indicators that may be lit.
2. Press the Video button and Audio button as necessary to select video, audio, or both
for configuration.
3. Select the desired input and one or more outputs by pressing the input and output
buttons.
• Input buttons and output buttons light or blink:
• Amber to indicate video and audio ties
• Green to indicate video only ties
• Red to indicate audio only ties
• To indicate potential ties, output buttons blink the appropriate color when an input
is selected.
• To indicate current ties, output buttons light steadily the appropriate color when an
input is selected.
• To clear unwanted outputs, press and release the associated lit output buttons. To
indicate potential unties, output buttons blink the appropriate color when an output
is deselected but not untied from the input.
4. Press and release the Enter button to accept the tie or to break an existing tie.
5. Repeat steps 1 through 4 to create or clear additional ties until the desired configuration
is complete.
NOTES:
• Only one video input and one audio input can be tied to an output.
• If a tie is made between an input and an output, and the selected output was
previously tied to another input, the older tie is broken in favor of the newer tie.
• If an input with no tie is selected, only the button for the selected input lights.
• When the Video button and the Audio button are lit, and if an input with an audio
tie but no video tie is selected, the button for the input and the button for the output
light the appropriate color (amber, green, or red).
• As each input and output is selected, the associated output button blinks the
appropriate color to indicate a tentative tie. Buttons for outputs that were already
tied to the input light the appropriate color steadily. Outputs that are already tied
can be left on, along with new blinking selections, or toggled off by pressing the
associated output button.