Extron electronics DTP CrossPoint 4K Series - Performing a Mode 1 Reset

DTP CrossPoint 4K Series Matrix Switchers • Operation 52
Performing a Mode 1 Reset
The hard reset function restores the switcher to the base firmware that it was shipped with.
After a hard reset, events do not automatically start, but user settings and files are retained.
Perform a hard reset as follows:
NOTE: The hard reset restores the factory-installed firmware. The switcher reverts to
the most recent firmware (the firmware that was running before the reset) the next time
power is cycled unless a firmware update is performed before the power cycle.
1. If necessary, turn off power to the switcher.
2. Use a small screwdriver to press and hold the switcher (not IPCP) Reset button on the
right side of the rear panel while you apply AC power to the switcher (see figure 35).
Powe
r
RESET
RESET
Press and hold the button
while you apply power.
Release the Reset button.
The switcher blinks the front panel
button indicators green, red, and
amber and then turns them off.
Continue to hold the Reset b
utton until
all input and output b
uttons return to
either unlit or to bac
kground illumination
and the
Video and Audio buttons turn on.
Figure 35. Hard Reset