DTP CrossPoint 4K Series Matrix Switchers • Operation 48
Background Illumination
The buttons on the front panel can be set to provide amber background illumination at
all times or the background illumination can be turned off. To toggle the background
illumination on or off, press and hold the Input 1 and Input 2 buttons simultaneously for
approximately 2 seconds (see figure 31).
1
2
7
8
Press and hold the buttons.
After the illumination status of the
b
uttons changes (after appro
ximately
2 seconds), release the buttons.
Figure 31. Toggling Background Illumination On or Off
Setting the Front Panel Locks (Executive Modes)
The matrix switcher has three levels of front panel security lock that limit the operation of the
switcher from the front panel. The three levels are:
• Lock mode 0 — The front panel is completely unlocked. All front panel functions are
available.
• Lock mode 1 — All changes are locked from the front panel (except for setting Lock
mode 2). Some functions can be viewed.
• Lock mode 2 — Basic functions are unlocked. Advanced features are locked and can
be viewed only.
NOTE: The switcher is shipped from the factory in Lock mode 2.
Basic functions consist of:
• Making ties
• Recalling presets
• Changing Lock modes
Advanced functions consist of:
• Configuring the TP insertion ports
• Configuring the input audio
• Setting the rear panel remote port baud rate
To Next Page
Loading...
