Extron electronics DTP CrossPoint 4K Series - Set Passwords

DTP CrossPoint 4K Series Matrix Switchers • HTML Pages 158
Set Passwords
Click Set in the Passwords panel (see figure 87,
1
) to open the Passwords dialog box.
1111111111
44
44444444
22
22222222
33
33333333
22
22222222
33
33333333
Figure 87. Passwords Dialog Box
The fields in the Passwords dialog box are for entering and verifying administrator and user
passwords. Passwords are case-sensitive and are limited to 12 upper case and lower case
alphanumeric characters. Each password must be entered twice: once in the Password
field (
2
) and then again in the Confirm Password field (
3
). Characters in these fields are
masked by asterisks or dots (*****). If you do not want to password protect an access level,
leave both fields blank. After entering the desired password in both fields, click the Apply
button (
4
).
NOTES:
• An administrator password must be created before a user password can be
created.
• You cannot clear an existing password using this dialog box (see the Reset (clear)
administrator password and Reset (clear) user password SIS commands,
both on page 83).