Extron electronics DTP CrossPoint 4K Series - Making Labels from Paper Templates; Installing Labels in the Buttons

DTP CrossPoint 4K Series Matrix Switchers • Reference Information 173
Making Labels from Paper Templates
The next page provides strips of blank button labels (see Button Label Blanks on the next
page). If desired, copy them or cut them out, write button information in each button area as
desired, and put them in the windows of the input or output buttons.
Installing Labels in the Buttons
Install new labels in the front panel buttons as follows:
1. Remove the button from the matrix switcher; use a small, flat bladed screwdriver such
as an Extron Tweeker to gently pry a button out from the front panel (see figure 93).
TEXT
Separate the two-
piece button here at
the corner.
Pry the two
pieces apart.
Diffuser
Base
Button Label
Clear Lens
Figure 93. Illuminated Button Label Replacement
2. Locate the notch in the corner of one side of the clear button cap lens.
3. Separate the white backing (diffuser) from the clear button cap (lens); insert the blade of
the small screwdriver into the corner notch and gently twist the blade.
4. Save the translucent white diffuser, but remove the label insert from the transparent
button cap lens.
5. Insert the replacement button label into the button cap. Check for correct label
orientation.
6. Align the white diffuser plate with the cap (lens). The bumps on the diffuser plate should
be aligned (top and bottom) with the notches on the clear button cap. Firmly snap it into
place.
7. Align the tabs on the base of the matrix switcher with the notches on the diffuser plate.
Gently, but firmly, press the reassembled button into place in the front panel of the
switcher.
8. Repeat steps 1 to 7 as needed to relabel other buttons.