Extron electronics DTP CrossPoint 4K Series - Page 46

DTP CrossPoint 4K Series Matrix Switchers • Operation 38
Example 3: Remove a tie from a set of ties, 10x8 matrix size
NOTE: This example assumes that you have performed example 1 on page 36 and
example 2 on the previous page.
1. Clear all selections: Press and release the Esc button.
2. Select audio only for the tie: Press and release the Video button and the Audio
button as necessary to light Audio only.
I / O
VIDEO AUDIO
Press the Video button to toggle on and off.
The button is unlit or background illuminated when deselected.
Press the Audio button to toggle on and off
.
The button lights red when selected.
3. Select an input: Press and release the Input 5 button.
123 4 567 8 9 10
INPUTS
12345678
OUTPUTS
The Output 2 button does not light to indicate the tie
created in example 2 because that tie is video only.
The Output 1, Output 3, and Output 4 buttons light
red to indicate the audio ties created in example 1.
Press the button.
The button lights red.
4. Select the output: Press and release the Output 4 button.
C O N T R O L
PRESET ENTER
ESCVIEW
12345678
OUTPUTS
Press the b
utton.
The b
utton blinks red to indicate the pending change:
the
audio input will be untied.
The Enter button blinks
green to indicate the need
to confirm the change.
5. Confirm the change: Press and release the Enter button.
ENTER
All input buttons and output buttons
return to unlit or bac
kground illumination.
Press the Enter button
to confirm the change.
The
Enter button returns to
unlit or background illumination.
The current configuration (see figure 29) is now:
• Video — Input 5 video is tied to output 1, output 2, output 3, and output 4.
• Audio — Input 5 audio is tied to output 1 and output 3.
Input
Output
1
3
4
2
5
Video
Audio
Figure 29. Final Configuration, Example 3