Extron electronics DTP CrossPoint 4K Series - Page 28

DTP CrossPoint 4K Series Matrix Switchers • Installation 20
• Patch (straight) cable —
• TP input and output ports — Shielded twisted pair (STP) for connection to Extron
DTP transmitters and receivers, XTP matrix switchers, or HDBaseT-enabled devices.
• Expansion port — STP for connection between the matrix switcher and a
DMP 128. A shielded, terminated 1-foot cable is included with the DMP 128.
• LAN ports — Unshielded twisted pair (UTP) or STP for connection of the LAN port
to an Ethernet LAN or direct connection between the switcher and a computer.
• Crossover cable —
• LAN ports — UTP or STP for direct connection between the DTP CrossPoint 4K
matrix switcher and a connected computer.
LAN ports
The LAN ports require CAT 3, CAT 5e, or CAT 6a, crossover or patch cables.
The cable used depends on your network speed. The switcher LAN port supports both
10 Mbps (10Base-T — Ethernet) and 100 Mbps (100Base-T — Fast Ethernet), half-duplex
and full-duplex Ethernet connections. TP inputs and outputs support 100Base-T only.
• 10Base-T Ethernet requires CAT 3 UTP or STP cable at minimum.
• 100Base-T (max. 155 Mbps) or 1000Base-T Fast Ethernet require CAT 5e UTP or STP
cable at minimum.
For ports on an IPCP module, see the IPCP Pro Series User Guide at www.extron.com to
make all network connections and to configure and operate the control processor.
TP and Expansion ports
The TP input and output ports are compatible with Extron XTP DTP 24 SF/UTP cables, as
well as CAT 5e, 6, 6a, and 7 shielded twisted pair (F/UTP, SF/UTP, and S/FTP) cable. The
Expansion port requires CAT 5e, 6, 6a, or 7 shielded twisted pair cable.
For the TP ports only —
ATTENTION:
• Do not connect these ports to a computer data or telecommunications network.
• Ne connectez pas ces port à des données informatiques ou à un réseau de
télécommunications.
• Do not use Extron UTP23SF-4 Enhanced Skew-Free AV UTP cable or STP201 cable
to link the switcher to Extron DTP or XTP products or HDBaseT-enabled devices.
• N’utilisez pas le câble AV Skew-Free UTP version améliorée UTP23SF d’Extron ou
le câble STP201 pour relier la grille de commutation avec des produits XTP ou DTP
d’Extron, ou des appareils équipés HDBaseT.
• To ensure FCC Class A and CE compliance, STP cables and STP connectors are
required.
• Afin de s’assurer de la compatibilité entre FCC ClasseA et CE, les câbles STP et
les connecteurs STP sont nécessaires.
• The TP ports can provide remote power to connected devices. Remote power is
intended for indoors use only. No part of a network that uses remote power can be
routed outdoors.
• Les ports paires torsadées peuvent fournir une alimentation à distance aux
appareils connectés. L’alimentation à distance est exclusivement réservée à un
usage en intérieur. Un réseau utilisant une alimentation à distance ne peut pas être
routé en extérieur.