EasyManua.ls Logo

Extron electronics IN1806 Series - Page 69

Extron electronics IN1806 Series
122 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
IN1806 and IN1808 Series Scaling Presentation Switchers • SIS Configuration and Control 61
X7@
= Key effect
0 = Disabled (default)
1 = Transparency
2 = RGB key
3 = Level key
4 = Alpha key
X8)
= Audio playback file slot number
1 through 16
Highest priority for playback is slot 1, descending to
lowest priority slot 16.
X8@
= Playback state
0 = Stop or stopped
1 = Play or playing
X8#
= Repeat
0 = No
1 = Yes
NOTE: Setting the repeat mode to 0 during
continuous playback causes play to stop after the
end of the current iteration.
X8$
= Playback delay Number of seconds to wait before the audio file repeats
(valid only if
X8#
= 1 [repeat]).
1 through 300 (1-300 seconds delay between audio
playbacks)
0 = No delay
X8%
= Configuration type
0 = IP configuration (ip.cfg)
2 = Unit-specific parameters (box.cfg)
X8^
= Number of open connections
0-<maximum number of open connections>
X8&
= IP address
Format nnn.nnn.nnn.nnn
Default = 192.168.254.254
Leading zeros in each of the four octets are optional in
setting values, and are suppressed in returned values.
X8*
= Gateway IP address
Format nnn.nnn.nnn.nnn
Default = 0.0.0.0
Leading zeros in each of the four octets are optional in
setting values, and are suppressed in returned values.
X8(
= Subnet mask
Format nnn.nnn.nnn.nnn
Default = 255.255.255.0
Leading zeros in each of the four octets are optional in
setting values, and are suppressed in returned values.
X9)
= Hardware (MAC) address
00-05-A6-xx-xx-xx
X9!
= Password Length is 1-128 characters.
All human-readable characters are allowed except
|
.
The password cannot be a single space.
Passwords are case-sensitive.
A user password cannot be assigned if no
administrator password exists. An E14 error code is
returned.
If the admin password is cleared, the user password
is cleared as well.
X9@
= Default unit name Combination of the model name and the last three
hexadecimal character pairs of the unit MAC address
(Example: IN1808-IPCP-SA-15-9E-B0)
X9#
= Subnet mask in CISG
commands
Prefix representing subnet mask bits (subnet mask value
in CISG commands).
Default = /24, which represents the default subnet mask,
255.255.255.0.

Table of Contents