Fagor CNC 8065 - Page 361

Installation manual
CNC 8060
CNC 8065
TOOL AND MAGAZINE MANAGEMENT.
7.
(REF: 1402)
·361·
Turret type magazine.
7.7.2 Detailed description of the operations of the magazine.
Here is a sample of a detailed description of the valid operations for this magazine. For each
operation, it indicates which of the TAKEPOS, LEAVEPOS, NEXTPOS and MZID signals are
involved and their meanings. It also shows the sequence to follow to complete the operation.
The TAKEPOS, LEAVEPOS and NEXTPOS signals can assume the following values.
TMOPERATION = 1
Assume the current tool as active tool.
The sequence of this operation is the following.
1 After ending this operation, activate the MZTOSPDL mark.
TMOPERATION = 3
Insert a ground tool in the spindle.
The sequence of this operation is the following.
1 When the operation is completed, activate the mark: GRTOSPDL.
TMOPERATION = 4
Leave the spindle tool on the ground.
The sequence of this operation is the following.
1 When the operation is completed, activate the mark: SPDLTOGR.
TMOPERATION = 9
Take a ground tool to the magazine going through the spindle.
The sequence of this operation is the following.
1 Leave the ground tool in the spindle and activate the mark GRTOSPDL.
TMOPERATION = 10
Take a tool from the magazine and leave on the ground going through the spindle.
The sequence of this operation is the following.
1 Leave the tool of the spindle on the ground and activate the mark SPDLTOGR.
TMOPERATION = 11
Orient the magazine.
The sequence of this operation is the following.
1 When the operation is completed, activate the mark MZROT.
Value Meaning
0 Do nothing.
# Magazine position.
-4 Ground tool.
TAKEPOS Magazine position to pick up the tool.
TAKEPOS Ground tool.
LEAVEPOS Magazine position to leave the tool.
TAKEPOS Magazine position to pick up the tool.
LEAVEPOS Ground tool.