·362·
Installation manual
CNC 8060
CNC 8065
7.
TOOL AND MAGAZINE MANAGEMENT.
(REF: 1402)
Turret type magazine.
TMOPERATION = 15
Select a magazine position.
The sequence of this operation is the following.
1 When the operation is completed, activate the mark MZROT.
TAKEPOS This register takes the value of ·0· if it is an absolute positioning and
the value of ·1· if it is a relative positioning.
LEAVEPOS This register takes the value of ·0· if it is a positive relative positioning
and the value of ·1· if it is a negative relative positioning.
NEXTPOS In an absolute positioning, this register indicates the position to reach
and, in a relative positioning, the number of positions to rotate.
To Next Page
Loading...
