Installation manual
CNC 8060
CNC 8065
TOOL AND MAGAZINE MANAGEMENT.
7.
(REF: 1402)
·373·
Synchronous magazine without changer arm.
This operation is an optimization of the tool change that permits orienting two magazines
while machining. Activate the MZROT mark in both magazines to indicate that the operation
has been completed, whether the magazines have been oriented or not.
TMOPERATION = 14
Leave the spindle tool in the magazine and take a tool from another magazine.
The sequence of this operation is the following.
1 Leave the tool of the spindle in the magazine and activate the mark SPDLTOMZ.
2 Leave the tool of the magazine in the spindle and activate the mark MZTOSPDL.
NEXTPOS=# Magazine position to leave the tool.
TAKEPOS=# Magazine position to pick up the tool.
MZID The lower portion of this register indicates the destination magazine
for the tool and the higher portion the source magazine for the tool.
TAKEPOS=# Magazine position to pick up the tool.
LEAVEPOS=# Magazine position to leave the tool.
MZID The lower portion of this register indicates the destination magazine
for the tool and the higher portion the source magazine for the tool.
To Next Page
Loading...
