Fagor CNC 8065 - Page 506

·506·
Installation manual
CNC 8060
CNC 8065
9.
CONCEPTS.
(REF: 1402)
Calculation of the kinematics dimensions.
Calculation of parameter TDATA11.
First contact.
Second contact.
Calculation of parameter TDATA5.
First contact.
1 Position rotary axes B and C at 0º.
2 Place the dial indicator on the table, in the
direction of the Y axis.
3 Move the table in the Y axis until the dial
indicator and the cylinder touch each other
at point 1.
4 Preset Y=R so Y=0 coincides with the shaft
of the cylinder placed in the spindle.
1 Remove the dial indicator, without loosening
it and position the rotary C axis at 180º.
2 Touch with the dial indicator at point 2.
3 Jot down the position value (coordinate)
shown at the CNC ΔY).
Solution.
TDATA1 Dimensions to calculate.
ΔY Coordinate shown by the CNC.
1 Position rotary axes B and C at 0º.
2 Place the dial indicator on the table, in the
direction of the X axis.
3 Move the table in the X axis until the dial
indicator and the cylinder touch each other
at point 1.
4 Preset X=0.
Y
Z
B=0º
C=0º
1
R
B=0º
C=180º
Y
Z
2
TDATA1
TDATA1 ΔY=
X
Z
B=0º
C=0º
1
TDATA5