Fagor CNC 8065 - Page 545

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·545·
Variables related to general machine parameters.
(V.)MPG.ROPARMIN
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Lower limit for global read-only arithmetic parameters.
The variable will return a ·0· if no range has been defined or the range is wrong.
(V.)MPG.ROPARMAX
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Upper limit for global read-only arithmetic parameters.
The variable will return a ·0· if no range has been defined or the range is wrong.
(V.)MPG.MAXCOMP
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Upper limit for common arithmetic parameters.
(V.)MPG.MINCOMP
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Lower limit for common arithmetic parameters.
(V.)MPG.BKUPCUP
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Number of common non-volatile arithmetic parameters.
CROSS COMPENSATION TABLE.
(V.)MPG.MOVAXIS[tbl]
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Cross compensation table [tbl]. Logic number of the master axis.
The variable will return a ·0· value if the table has not been defined.
Syntax.
·tbl· Table number.
(V.)MPG.COMPAXIS[tbl]
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Cross compensation table [tbl]. Logic number of the compensated axis.
V.MPG.ROPARMIN
V.MPG.ROPARMAX
V.MPG.MAXCOMP
V.MPG.MINCOMP
V.MPG.BKUPCUP
V.MPG.MOVAXIS[3] Third cross compensation table.