Fagor CNC 8065 - Page 544

·544·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
Variables related to general machine parameters.
Values of the variable.
This variable returns one of the following values.
DEFAULT CONDITIONS (SYTEM).
(V.)MPG.INCHES
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Default measuring units.
Values of the variable.
This variable returns one of the following values.
ARITHMETIC PARAMETERS.
(V.)MPG.MAXLOCP
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Upper limit for local arithmetic parameters.
(V.)MPG.MINLOCP
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Lower limit for local arithmetic parameters.
(V.)MPG.MAXGLBP
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Upper limit for global arithmetic parameters.
(V.)MPG.MINGLBP
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Lower limit for global arithmetic parameters.
Value. Meaning.
1 RS232.
2 RS485.
3 RS422.
V.MPG.INCHES
Value. Meaning.
0 Millimeters.
1 Inches.
V.MPG.MAXLOCP
V.MPG.MINLOCP
V.MPG.MAXGLBP
V.MPG.MINGLBP