Fagor CNC 8065 - Page 550

·550·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
Variables related to general machine parameters.
NUMBERING OF ANALOG INPUTS FOR TEMPERATURE
SENSORS PT100.
(V.)MPG.NPT100
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Total number of active PT100 inputs.
(V.)MPG.PT100[nb]
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Analog input associated with the PT100 input.
Syntax.
·nb· PT100 input number.
PROBE SETTING.
(V.)MPG.PROBE
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
There is a probe.
Values of the variable.
This variable returns one of the following values.
(V.)MPG.PROBETYPE1
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Probe type 1, depending on where it is connected.
Values of the variable.
This variable returns one of the following values.
V.MPG.NPT100
V.MPG.NPT100[3] Third PT100 input.
V.MPG.PROBE
Value. Meaning.
0No.
1Yes.
V.MPG.PROBETYPE1
Value. Meaning.
0 Remote probe.
1 Local probe.