Fagor CNC 8065 - Page 551

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·551·
Variables related to general machine parameters.
(V.)MPG.PROBETYPE2
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Probe type 2, depending on where it is connected.
Values of the variable.
This variable returns one of the following values.
(V.)MPG.PRBDI1
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Number of the input associated with probe 1.
For remote probes, this parameter indicates the digital input number; for local probes, it
indicates the local probe input number.
The variable will return a ·0· value if no digital input has been defined.
(V.)MPG.PRBDI2
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Number of the input associated with probe 2.
For remote probes, this parameter indicates the digital input number; for local probes, it
indicates the local probe input number.
The variable will return a ·0· value if no digital input has been defined.
(V.)MPG.PRBPULSE1
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Logic level to activate probe 1.
Values of the variable.
This variable returns one of the following values.
(V.)MPG.PRBPULSE2
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Logic level to activate probe 2.
V.MPG.PROBETYPE2
Value. Meaning.
0 Remote probe.
1 Local probe.
V.MPG.PRBDI1
V.MPG.PRBDI2
V.MPG.PRBPULSE1
Value. Meaning.
0 Low logic level (0 V).
1 High logic level (5 V / 24 V).
V.MPG.PRBPULSE2