Fagor CNC 8065 - Page 553

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·553·
Variables related to general machine parameters.
Delay of the device associated with synchronized switching.
PWM (PULSE-WIDTH MODULATION).
(V.)MPG.PWMOUTPUT
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Local digital output associated with the PWM.
Values of the variable.
This variable returns one of the following values.
(V.)MPG.PWMCANCEL
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Cancel the PWM after an M30 or a reset.
Values of the variable.
This variable returns one of the following values.
BACKUP OF NON-VOLATILE DATA.
(V.)MPG.BKUPREG
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Number of non-volatile PLC registers.
(V.)MPG.BKUPCOUN
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Number of non-volatile PLC counters.
V.MPG.SWTDELAY
(V.)MPG.PWMOUTPUT
Value. Meaning.
0PWM missing.
1 Local output 1 (pin LI/O1).
2 Local output 2 (pin LI/O2).
(V.)MPG.PWMCANCEL
Value. Meaning.
0No.
1Yes.
V.MPG.BKUPREG
V.MPG.BKUPCOUN