Fagor CNC 8065 - Page 555

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·555·
Variables related to general machine parameters.
Syntax.
·jog· Number of jog panel.
Values of the variable.
This variable returns one of the following values.
Remarks.
The CNC numbers the operator panels following the order (sequence) that they occupy in
the CAN bus (Address switch). The first jog panel will be the one with the lowest number and
so on.
PLC TYPE.
(V.)MPG.PLCTYPE
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
PLC type.
Values of the variable.
This variable returns one of the following values.
RENAME THE AXES AND THE SPINDLES.
(V.)MPG.RENAMECANCEL
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Cancel the name change for the axes and the spindles.
Values of the variable.
This variable returns one of the following values.
V.MPG.KEYBDCH[2] Jog panel ·2·.
Value. Meaning.
0 Active channel.
1 Channel ·1·.
2 Channel ·2·.
3 Channel ·3·.
4 Channel ·4·.
V.MPG.PLCTYPE
Value. Meaning.
0IEC.
1 IEC+Fagor.
2 Fagor.
V.MPG.RENAMECANCEL
Value. Meaning.
0No.
1Yes.