Fagor CNC 8065 - Page 571

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·571·
Variables related to the machine parameters of the channels.
Remarks.
The reading from the PLC will be given in tenths (x10); i.e. if the parameter value is ·10·, the
PLC reading will return a value of ·100·.
(V.)[ch].MPG.RAPIDOVR
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. Override acts in G00 (from 0 to 100%).
This parameter indicates whether the feedrate % may be modified (between 0% and 100%)
or not when working in G0; if not possible, it will stay fixed at 100%.
Regardless of the value assigned to this parameter, the override always attends to the 0%
position and never acts over 100%. It is always possible to change the % of feedrate when
moving in jog mode.
Syntax.
·ch· Channel number.
Values of the variable.
This variable returns one of the following values.
(V.)[ch].MPG.FEEDND
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. Apply the programmed feedrate to all the axes of the channel
This parameter indicates whether the programmed feedrate is applied to all the axes of the
channel or only to the main axes. If it is only applied to the main axes, the rest of the axes
move at their corresponding feedrate to end the movement of them all at the same time.
Syntax.
·ch· Channel number.
Values of the variable.
This variable returns one of the following values.
OVERRIDE OF THE DYNAMICS FOR HSC.
(V.)[ch].MPG.MINDYNOVR
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. Minimum override for the dynamics in HSC.
V.[2].MPG.RAPIDOVR Channel ·2·.
Value. Meaning.
0No.
1Yes.
V.[2].MPG.FEEDND Channel ·2·.
Value. Meaning.
0 No. The programmed feedrate is only applied to the main
axes.
1 Yes. The programmed feedrate is applied to all the axes of
the channel.