Fagor CNC 8065 - Page 615

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·615·
Variables related to axis and spindle machine parameters.
(V.)[ch].MPA.SHARE[nb].xn
(V.)[ch].MPA.SHARE[nb].sn
(V.)[ch].SP.SHARE[nb].sn
Variable that can only be read from the program, PLC and interface.
Variable valid for rotary and linear axes as well as for spindles.
Variable valid for analog drive, position Sercos and velocity Sercos.
The variable returns the value of block preparation.
Channel [ch]. Percentage of signal going through the filter.
Syntax.
·ch· Channel number.
·nb· Filter number.
·xn· Name, logic number or index of the axis.
·sn· Name, logic number or index of the spindle.
PARAMETER SETS.
(V.)[ch].MPA.NPARSETS.xn
(V.)[ch].MPA.NPARSETS.sn
(V.)[ch].SP.NPARSETS.sn
Variable that can only be read from the program, PLC and interface.
Variable valid for rotary and linear axes as well as for spindles.
Variable valid for analog drive, position Sercos and velocity Sercos.
The variable returns the value of block preparation.
Channel [ch]. Number of parameter sets available.
Syntax.
·ch· Channel number.
·xn· Name, logic number or index of the axis.
·sn· Name, logic number or index of the spindle.
V.MPA.SHARE[3].Z Z axis.
V.MPA.SHARE[3].S Spindle S.
V.SP.SHARE[3].S Spindle S.
V.SP.SHARE[3] Master spindle.
V.MPA.SHARE[3].4 Axis or spindle with logic number ·4·.
V.[2].MPA.SHARE[3].1 Axis with index ·1· in the channel ·2·.
V.SP.SHARE[3].2 Spindle with index ·2· in the system.
V.[2].SP.SHARE[3].1 Spindle with index ·1· in the channel ·2·.
V.MPA.NPARSETS.Z Z axis.
V.MPA.NPARSETS.S Spindle S.
V.SP.NPARSETS.S Spindle S.
V.SP.NPARSETS Master spindle.
V.MPA.NPARSETS.4 Axis or spindle with logic number ·4·.
V.[2].MPA.NPARSETS.1 Axis with index ·1· in the channel ·2·.
V.SP.NPARSETS.2 Spindle with index ·2· in the system.
V.[2].SP.NPARSETS.1 Spindle with index ·1· in the channel ·2·.