Fagor CNC 8065 - Page 624

·624·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
Variables related to the sets of machine parameters.
(V.)[ch].MPA.INPOSW[set].xn
(V.)[ch].MPA.INPOSW[set].sn
(V.)[ch].SP.INPOSW[set].sn
Variable that can only be read from the program, PLC and interface.
Variable that may be modified from the environment of the oscilloscope and setup.
Variable valid for rotary and linear axes as well as for spindles.
Variable valid for analog drive, position Sercos and velocity Sercos.
The variable returns the execution value; reading it interrupts block preparation.
In-position zone.
Syntax.
·ch· Channel number.
·set· Parameter set.
·xn· Name, logic number or index of the axis.
·sn· Name, logic number or index of the spindle.
BACKLASH COMPENSATION IN MOVEMENT REVERSAL.
(V.)[ch].MPA.BACKLASH[set].xn
(V.)[ch].MPA.BACKLASH[set].sn
(V.)[ch].SP.BACKLASH[set].sn
Variable that can only be read from the program, PLC and interface.
Variable that may be modified from the environment of the oscilloscope and setup.
Variable valid for rotary and linear axes as well as for spindles.
Variable valid for analog drive, position Sercos and velocity Sercos.
The variable returns the execution value; reading it interrupts block preparation.
Amount of backlash to be compensated.
With linear encoders (scales), this parameter will be set to ·0·.
Syntax.
·ch· Channel number.
·set· Parameter set.
·xn· Name, logic number or index of the axis.
·sn· Name, logic number or index of the spindle.
V.MPA.INPOSW[3].Z Z axis.
V.MPA.INPOSW[3].S Spindle S.
V.SP.INPOSW[3].S Spindle S.
V.SP.INPOSW[3] Master spindle.
V.MPA.INPOSW[3].4 Axis or spindle with logic number ·4·.
V.[2].MPA.INPOSW[3].1 Axis with index ·1· in the channel ·2·.
V.SP.INPOSW[3].2 Spindle with index ·2· in the system.
V.[2].SP.INPOSW[3].1 Spindle with index ·1· in the channel ·2·.
V.MPA.BACKLASH[3].Z Z axis.
V.MPA.BACKLASH[3].S Spindle S.
V.SP.BACKLASH[3].S Spindle S.
V.SP.BACKLASH[3] Master spindle.
V.MPA.BACKLASH[3].4 Axis or spindle with logic number ·4·.
V.[2].MPA.BACKLASH[3].1 Axis with index ·1· in the channel ·2·.
V.SP.BACKLASH[3].2 Spindle with index ·2· in the system.
V.[2].SP.BACKLASH[3].1 Spindle with index ·1· in the channel ·2·.